Hyundai Santa Fe: Audio / Audio Remote Control. Repair procedures

Hyundai Santa Fe (TM) 2019-2024 Service Manual / Body Electrical System / Audio / Audio Remote Control. Repair procedures

Inspection

Check for resistance between terminals in left switch position.

[Audio/Bluetooth]

Switch	Connector terminal	Resistance (± 3%)
SEEK Up	1 - 6	430 Ω
SEEK Down	1 - 6	1.1 kΩ
MODE	1 - 6	2.11 kΩ
MUTE	1 - 6	3.11 kΩ
Volume up	1 - 6	4.61 kΩ
Volume down	1 - 6	6.81 kΩ
Voice	1 - 6	10.71 kΩ
END	1 - 6	18.91 kΩ
SEND	1 - 6	40.91 kΩ

Check for resistance between terminals in right switch position.

[Trip/Cruise]

Switch	Connector terminal	Resistance (± 3%)
CANCEL	2 - 6	390 Ω
SET (-)	2 - 6	610 Ω
RES (+)	2 - 6	910 Ω
Cruise ON/OFF	2 - 6	1.38 kΩ
Cruise Mode	2 - 6	2.13 kΩ
Smart Cruise	2 - 6	3.63 kΩ
Trip Group	1 - 6	390 Ω
Trip Up	1 - 6	610 Ω
Trip Down	1 - 6	910 kΩ
Trip OK	1 - 6	1.38 kΩ

Removal

1.	Disconnect the negative (-) battery terminal.

2.	Remove the driver airbag module. (Refer to Restraint - "Driver Airbag (DAB) Module and Clock Spring")

3.	Remove the steering wheel. (Refer to Steering System - "Steering Column and Shaft")

4.	Remove the steering wheel cover (A) after loosening the screws.

5.	Loosen the screws and then disconnect the steering wheel remote control switch connector.

6.	Remove the remote control switchs (A).

Installation

1.	Install the remote control switch on the steering wheel.

2.	Install the steering wheel.

Reconnect the remote control switch connector and airbag connectors.

Make sure that the switch connector is plugged in properly.

4.	Install the driver airbag module.

5.	Connect the negative (-) battery terminal.

Audio Remote Control. Schematic diagrams

USB Jack. Description and operation

Description The AUX, iPod and USB JACK on the center console is for customers who like to listen to external portable music players like the MP3, iPod, earphone, USB memory stick, CD player and etc...

Other information:

Hyundai Santa Fe (TM) 2019-2024 Owner's Manual: Vehicle load limit

Two labels on your driver’s door sill show how much weight your vehicle was designed to carry: the Tire and Loading Information Label and the Certification Label. Before loading your vehicle, familiarize yourself with the following terms for determining your vehicle’s weight ratings, from the vehicle’s specifications and the Certification Label: Base Curb Weight This is the weight of the vehicle including a full tank of fuel and all standard equipment...

Hyundai Santa Fe (TM) 2019-2024 Service Manual: Components and components location

Components [2WD] 1. Rear shock absorber 2. Rear lower arm 3. Rear stabilizer bar 4. Rear cross member 5. Rear upper arm 6. Rear assist arm 7. Trailing arm [4WD] 1...