Hyundai Santa Fe: Crash Pad / Crash Pad Side Cover. Repair procedures
•
|
Put on gloves to prevent hand injuries.
|
|
•
|
When removing with a flat-tip screwdriver or remover, wrap protective
tape around the tools to prevent damage to components.
|
•
|
Use a plastic panel removal tool to remove interior trim pieces
without marring the surface.
|
•
|
Take care not to bend or scratch the trim and panels.
|
|
1. |
Using a screwdriver or remover, remove the crash pad side cover (A).
[LH]
[RH]
|
2. |
To install, reverse removal procedure.
• |
Replace any damaged clips (or pin-type retainers).
|
|
|
Component Location
[LH]
1. Crash pad
side cover [LH]
[RH]
1...
Other information:
Malfunction Indicator Lamp (MIL)
This indicator light illuminates:
When you set the ignition switch or the Engine Start/Stop button to
the ON position.
- The malfunction indicator light illuminates for about 3 seconds and then goes
off.
Whenever there is a malfunction with either the emission control system
or the engine or the vehicle powertrain...
Inspection
Throttle Position Sensor (TPS)
1.
Connect the diagnostic tool on the Data Link Connector (DLC).
2.
Start the engine and measure the output voltage of TPS 1 and 2 at C...
Categories
The front seat can be adjusted by using the control switches located on the outside
of the seat cushion. Before driving, adjust the seat to the proper position so that
you can easily control the steering wheel, foot pedals and controls on the instrument
panel.
WARNING
NEVER allow children in the vehicle unattended. The power seats are operable
when the vehicle is turned off.
read more