Hyundai Santa Fe: Front Seat / Front Seat Shield Outer Cover. Repair procedures
| •
|
Put on gloves to prevent hand injuries.
|
|
| •
|
When removing with a flat-tip screwdriver or remover, wrap protective
tape around the tools to prevent damage to components.
|
| •
|
Use a plastic panel removal tool to remove interior trim pieces
without marring the surface.
|
| •
|
Take care not to bend or scratch the trim and panels.
|
|
|
1. |
Remove the front seat assembly.
(Refer to Front Seat - "Front Seat Assembly")
|
|
2. |
Using a screwdriver and remove the forward cover.
|
|
3. |
Remove the front seat outer shield cover.
|
(1) |
Using a screwdriver or remover and remove the rear hook ①.
|
|
(2) |
Remove the lower hook ② by pulling it aside
|
|
(3) |
Remove the upper steel clip ③ and the hook ② by pulling them
aside.
|
|
(4) |
Remove the front seat outer shield cover (A) by pulling it forward
as shown by the arrow.
|
• |
Front Seat Outer Shield When removing the cover,
pay attention to the removal order and direction.
|
|
• |
Be careful not to damage the hooks and brackets.
|
|
|
|
|
4. |
Separate the front seat power swich connector (A).
|
|
5. |
To install, reverse removal procedure.
|
• |
Make sure the connector is plugged in properly.
|
|
• |
Replace any damaged clips (or pin-type retainers).
|
|
|
Other information:
Cabin air filter
[A] : Outside air, [B] : Recirculated air, [C] : Cabin air filter, [D] : Blower,
[E] : Evaporator core, [F] : Heater core
The cabin air filter is installed behind the glove box. It filters the dust or
other pollutants that enter the vehicle through the heating and air conditioning
system...
Prerequisite for activation
ISG system operates in the following situations.
The driver's seatbelt is fastened
The driver's door and hood are closed
The brake vacuum pressure is adequate
The battery sensor is activated and the battery is sufficiently charged
Outside temperature is not too low or too high
The vehicle is driven over a constant speed and stops
The climate control system satisfies the conditions
The vehicle is sufficiently warmed up
ISG related parts are working properly
The incline is gradual
The steering wheel is turned less than 180 degrees and then the vehicle
stops
Information
If the ISG light (white) is turned on on the instrument cluster and does not
meet the ISG system operating conditions, the ISG system is not activated...
Categories
1. Inside door handle
2. Power window switches
3. Power window lock button/Electronic child safety lock button
4. Side view mirror folding button
5. Side view mirror control switch
6. Central door lock switch
7. Instrument panel illumination control switch
read more
