Hyundai Santa Fe: Emergency situations / In case of an emergency while driving
If the engine stalls while driving
- Reduce your speed gradually, keeping a straight line. Move cautiously
off the road to a safe place.
- Turn on your hazard warning flasher.
- Try to start the engine again. If your vehicle will not start, we recommend
that you contact an authorized HYUNDAI dealer or seek other qualified assistance.
If the engine stalls at a crossroad or crossing
If the engine stalls at a crossroads or crossing, if safe to do so, shift the
gear to N (Neutral) and then push the vehicle to a safe location.
If you have a flat tire while driving
If a tire goes flat while you are driving:
- Take your foot off the accelerator pedal and let the vehicle slow down
while driving straight ahead. Do not apply the brakes immediately or attempt
to pull off the road as this may cause loss of vehicle control resulting in
an accident. When the vehicle has slowed to such a speed that it is safe to
do so, brake carefully and pull off the road. Drive off the road as far as possible
and park on firm, level ground. If you are on a divided highway, do not park
in the median area between the two traffic lanes.
- When the vehicle is stopped, press the hazard warning flasher button,
shift the gear to P (Park), apply the parking brake, and press the Engine Start/Stop
button to the OFF position.
- Have all passengers get out of the vehicle. Be sure they all get out on
the side of the vehicle that is away from traffic.
- When changing a flat tire, follow the instructions provided later in this
chapter.
The hazard warning flasher serves as a warning to other drivers to exercise extreme
caution when approaching, overtaking, or passing your vehicle.
It should be used whenever emergency repairs are being made or when the vehicle
is stopped near the edge of a roadway...
Be sure to shift the gear to N (Neutral) or P (Park). The engine starts
only when the gear is in N (Neutral) or P (Park).
Turn on the interior light...
Other information:
Description
Introduction of quick brake warning system (ESS)
In case of quick brake by driver, the brake lamp or turn signal is blinked to
warn against the vehicle at rear.
1.
Basic function (Blinking the brake lamp/emergency lamp)
–
Operation condition : In case of quick brake or operation of
ABS above in a certain speed
–
Releasing condition : In case of stopping the quick brake or
releasing the ABS operation
2...
Specification
▷ CMF68L-DIN
Item
Specification
Model type
CMF68L-DIN
Capacity [20HR/5HR] (AH)
68 / 54
Cold Cranking Amperage (A)
600
Reserve Capacity (Min)
110
Specific Gravity
1...
Categories
The armrest is located in the center of the rear seat. Pull the armrest down
from the seatback to use it.
read more