| Inspection |
| 1. |
With the washer motor connected to the reservoir tank, fill the reservoir
tank with water.
|
| 2. |
Remove the front bumper cover.
(Refer to Body - "Front Bumper Cover")
|
| 3. |
Connect positive (+) and negative (-) battery cables to terminals 3
and 2 respectively to see that the washer motor runs and water is pumped.
|
| 4. |
Check that the motor operates normally.
Replace the motor if it operates abnormally.
|
Inspection 1. Check for continuity between the terminals in each switch position as shown below. Switch Switch position Switch terminal Resistance (Ω, ±3.
Inspection 1. Turn the ignition switch OFF. 2. Disconnect the mode control actuator connector. 3. Verify that the mode control actuator operates to the defrost mode when connecting 12V to terminal 3 and grounding terminal 7.
Trouble Symptom Charts Trouble Symptom 1 Trouble Symptom 2 Trouble symptom Probable cause Remedy The set vehicle speed varies greatly upward or downward "Surging" (repeated alternating acceleration and deceleration) occurs after set