Hyundai Santa Fe: Steering wheel / Repair procedures

Hyundai Santa Fe (TM) 2019-2024 Service Manual / Steering System / Steering wheel / Repair procedures

Removal

1.	Turn the steering wheel so that the front wheels can face straight ahead.

2.	Turn the ignition switch OFF and disconnect the battery negative (-) cable.

3.	Remove the drive airbag module. (Refer to Restraint - "Drive Air Bag Module")

4.	Disconnect the steering wheel connector (A).

Remove the steering wheel after loosening the bolt (A).

Tightening torque :

44.1 - 49.0 N.m (4.5 - 5.0 kgf.m, 32.5 - 36.2 lb-ft)

•	Do not reuse the steering lock bolt.

•	When assembling, match the gear teeth as the below illustration.

Disassembly

[Non-Paddle Shift Type]

1.	Loosen the screw and then remove the lower cover (A).

2.	Disconnect the remote control switch connector (A).

3.	Loosen the screw and then remove the remote control switch (A).

4.	Remove the steering wheel bezel (A).

5.	Remove the steering wheel damper (A) after loosening the mounting bolts.

[Paddle Shift Type]

1.	Loosen the paddle shift switch mounting screw (A).

2.	Remove the paddle shift switch (A) after disconnecting the connector.

3.	Remove the lower cover (A) after loosening the screw.

4.	Disconnect the remote control switch connector (A).

5.	Remove the remote control switch (A) after loosening the screw.

6.	Remove the steering wheel bezel (A).

7.	Remove the steering wheel damper (A) after loosening the mounting bolts.

Reassembly

1.	To reassembly, reverse the disassembly procedure.

Installation

1.	To install, reverse the removal procedures.

Components and components location

Components 1. Lower cover 2. Switch bezel 3. Remote control switch 4. Paddle shift 5. Damper 6. Steering Wheel 7...

Heated Steering wheel. Description and operation

Other information:

Hyundai Santa Fe (TM) 2019-2024 Owner's Manual: Checking the coolant level

Check the condition and connections of all cooling system hoses and heater hoses. Replace any swollen or deteriorated hoses. The coolant level should be filled between the MAX and the MIN marks on the side of the coolant reservoir when the engine is cool...

Hyundai Santa Fe (TM) 2019-2024 Service Manual: Temperature Control Actuator. Repair procedures

Inspection 1. Turn the ignition switch OFF. 2. Disconnect the temperature control actuator connector. 3. Verify that the temperature control actuator operates to the cool position when connecting 12V to terminal 3 and grounding terminal 7...