Hyundai Santa Fe: Lighting System / Rheostat. Repair procedures

Hyundai Santa Fe (TM) 2019-2025 Service Manual / Body Electrical System / Lighting System / Rheostat. Repair procedures

Inspection

1.	Disconnect the negative (-) battery terminal.

2.	Remove the crash pad lower panel. (Refer to Body - "Crash Pad Lower Panel")

3.	Loosen the mounting screw, remove the crash pad garnish [LH] (A).

4.	Press the lock pin, separate the connector (A).

5.	Remove the rheostat switch (A) after loosening mounting screws.

Installation

1.	Install the rheostat switch.

2.	Install the crash pad garnish [LH]

3.	Connect the negative (-) battery terminal.

Rheostat. Components and components location

License Lamps. Repair procedures

Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the license lamp lens (A) from the panel after loosening a screw...

Other information:

Hyundai Santa Fe (TM) 2019-2025 Service Manual: Crash Pad Lower Panel. Repair procedures

Replacement • Put on gloves to prevent hand injuries. • When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components...

Hyundai Santa Fe (TM) 2019-2025 Service Manual: Manifold Absolute Pressure Sensor (MAPS). Description and operation

Description Manifold Absolute Pressure Sensor (MAPS) is a speed-density type sensor and is installed on the surge tank. It senses absolute pressure of the surge tank and transfers the analog signal proportional to the pressure to the ECM...

Categories

Air bag collision sensors

WARNING

To reduce the risk of an air bag deploying unexpectedly and causing serious injury or death:

Do not hit or allow any objects to impact the locations where air bags or sensors are installed. Do not perform maintenance on or around the air bag sensors. If the location or angle of the sensors is altered, the air bags may deploy when they should not or may not deploy when they should. Installing bumper guards with nongenuine Hyundai or non-equivalent parts may adversely affect the collision and airbag deployment performance. Press the Engine Start/Stop button to the OFF or ACC position and wait for 3 minutes when the vehicle is being towed to prevent inadvertent air bag deployment. Have all air bag repairs performed by an authorized HYUNDAI dealer.