Symptom
|
Possible cause
|
Countermeasure
|
Wind noise around the door
|
Arise the gap on weatherstrip
|
Replace weatherstrip
|
Water leaks from panorama sunroof
|
Miss install of panorama sunroof frame weather strip and deforming
|
Replace
|
seal breakage
|
Fill with sealant
|
Wind noise on Panorama Sunroof
|
Deflector deformation and deviation
|
Replace or Remounting
|
Noise while panorama sunroof is working (noise when opening or closing)
|
Accumulation on the guide rail or rear rail
|
Clean guide rail/rear rail and apply grease
|
Tilt lever shoe excessive wear and breakage
|
Replace tilt lever shoe
|
Panorama Sunroof malfunction (Motor work, sunroof move partially or does
not move
|
Accumulation on the guide rail or rear rail
|
1. Clean guide rail/rear rail and apply grease
|
2. Adjustment or replacement
|
Poor engagement drive cable and motor pinion.
|
Adjustment or replacement
|
Sunroof operating resistance or interference (with cable, weather strip)
increased.
|
Adjustment or replacement
|
Motor initial value (position value) loss
|
Motor Initialization
|
motor noise
|
Poor engagement drive cable and motor pinion.
|
NNN
|
Motor pinion gear worn out or breakage
|
Motor Replacement
|
Drive cable worn out or breakage
|
Replacement
|
Door glass inoperative
|
Incorrect window glass installation
|
Repositioning
|
Motor failure or regulator breakage/deformationDamaged or faulty motor and
regulator
|
Adjustment or replacement
|
Door does not open or close completely
|
Door installation incorrect or striker/latch misalignment
|
Adjust position
|
Breakage, deformation, incorrect installation on door handle and latch.
Deformation of checker
|
Adjustment or replacement
|
Not enough grease on door hinge and checker
|
Apply grease
|
Hood does not open or close completely
|
Striker and latch are not properly aligned.
|
Adjustment
|
Hood installation incorrect
|
Adjustment
|
Incorrect hood bumper height
|
Adjustment
|
Water leak on windshield or rear window
|
Defective seal
|
Apply sealant
|
Defective flange
|
Adjustment
|
Wiper blade wiping/vibration noise
|
Glass surface contamination
|
Remove the foreign matters and water-repellent coating using a clean wet
towel.
|
Wiper blade contamination
|
Clean wiper blade using a clean wet towel.
|
Improper wiper arm angle
|
Check wiper arm angle specification and adjust.
|
Wiper blade worn out
|
Wiper blade replacement.
|
Wiper blade failure
|
Check if “tick” sound.
|
Wiper blade clearance
|
Press the left and right sides of the blade using tools.
|
Specifications
Items
Specification
Hood
Type
Rear hinged, gas lifter type
Front Door
Construction
Front hinged, frame door construction
Regulator system
Wire drum type
Locking system
Pin-fork system
Rear Door
Construction
Front hinged, frame door construction
Regulator system
Wire drum type
Locking system
Pin-fork system
Tail Gate
Type
Front hinged, gas lifter type
Seat Belts
Front
3 point type with Emergency Locking Retractor (E...
Other information:
The front seat can be adjusted by using the control switches located on the outside
of the seat cushion. Before driving, adjust the seat to the proper position so that
you can easily control the steering wheel, foot pedals and controls on the instrument
panel...
Description
On electronic injection systems, there is no longer a load lever that mechanically
controls the fuelling. The flow is caculated by the ECM depending on a number
of parameters, including pedal position, which is measured using a potentiometer...