Hyundai Santa Fe: AC Inverter System / AC Inverter Unit. Repair procedures

Hyundai Santa Fe (TM) 2019-2024 Service Manual / Body Electrical System / AC Inverter System / AC Inverter Unit. Repair procedures

Removal

1.	Disconnect the negative (-) battery terminal.

2.	Remove the right luggage side trim. (Refer to Body - "Luggage Side Trim")

3.	Disconnect the connector from the AC inverter unit.

4.	Remove the AC inverter unit after loosening the mounting nuts (3EA).

Installation

1.	Install the AC inverter unit.

2.	Install the luggage side trim.

Connect the negative (-) battery terminal.

–	Before starting repair work, turn off the engine and AC inverter.

–	You may get electrocuted if you work with the AC inverter on.

–	You may get electrocuted if you work on the AC inverter with you hands wet.

AC Inverter Unit. Components and components location

AC Inverter Oultet. Repair procedures

Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the rear console cover...

Other information:

Hyundai Santa Fe (TM) 2019-2024 Owner's Manual: Forced to restart engine

The engine is automatically restarted in the following situations. The brake vacuum pressure is low The engine has stopped for about 5 minutes The air conditioning is ON with the fan speed set to a certain high level The front defroster is ON The battery is weak The cooling and heating performance of the climate control system is unsatisfactory The vehicle is shifted to P (Park) or R (Reverse) when Auto Hold is activated The door is opened or the seatbelt is unfastened when Auto Hold is activated The EPB switch is pressed when Auto Hold is activated The Auto Stop () indicator blinks in green for 5 seconds on the instrument cluster when the engine is restarted...

Hyundai Santa Fe (TM) 2019-2024 Owner's Manual: Panoramic sunroof

If your vehicle is equipped with a sunroof, you can slide or tilt your sunroof with the sunroof control switch located on the overhead console. The sunroof can only be operated when the ignition switch or Engine Start/Stop button is in the ON or START position...