Hyundai Santa Fe: Air conditioning System / Auto Defogging Sensor. Description and operation
The auto defogging sensor is installed on the front window glass. The sensor
judges and sends signal if moisture occurs to blow out wind for defogging. The
air conditioner control module receives signal from the sensor and restrains
moisture and eliminate defog by controlling the intake actuator, A/C, auto defogging
actuator, blower motor rpm, and mode actuator.
Inspection
1.
Check the resistance of the ambient temperature sensor between terminals
1 and 2 whether it changes by changing the ambient temperature...
Inspection
To inspect and diagnose the sensor, refer to Self-Diagnosis procedure and DTC
guide.
Replacement
1...
Other information:
Replacement
[Front suction & Liquid pipe assembly]
1.
If a compressor is available, the air conditioner is operated for a
few minutes in the engine idle state and then the engine is stopped.
2...
Basic Troubleshooting
Basic Troubleshooting Guide
Customer Problem Analysis Sheet
Basic Inspection Procedure
Measuring Condition of Electronic Parts'
Resistance
The measured resistance at high temperature after vehicle running may be high
or low...
Categories
Engine oil pressure warning light
This warning light illuminates:
When the engine oil pressure is low.
If the engine oil pressure is low:
1. Drive carefully to the nearest safe location and stop your vehicle.
2. Turn the engine off and check the engine oil level (For more details, refer
to “Engine Oil” section in chapter 9). If the level is low, add oil as required.
read more