Hyundai Santa Fe: Crash Pad / Cluster Fascia Panel. Repair procedures
•
|
Put on gloves to prevent hand injuries.
|
|
•
|
When removing with a flat-tip screwdriver or remover, wrap protective
tape around the tools to prevent damage to components.
|
•
|
Use a plastic panel removal tool to remove interior trim pieces
without marring the surface.
|
•
|
Take care not to bend or scratch the trim and panels.
|
|
1. |
Using a screwdriver or remover, remove the cluster fascia panel (A).

|
2. |
To install, reverse the removal procedure.
• |
Replace any damaged clips (or pin-type retainers).
|
|
|
Replacement
•
Put on gloves to protect your hands...
Other information:
General Service Information
Protection of the Vehicle
Always be sure to cover fenders, seats, and floor areas prior to beginning work.
•
The support rod must be inserted into the hole near the edge
of the hood whenever you inspect the engine compartment to prevent
the hood from falling and causing possible injury...
Specifications
▷ Type : Hall effect sensor
▷ Specifications
Items
Specifications
Operation condition [°C(°F)]
(-40 to 150) -40 to 302
Sensor length (mm)
35...
Categories
Engine oil pressure warning light
.png)
This warning light illuminates:
When the engine oil pressure is low.
If the engine oil pressure is low:
1. Drive carefully to the nearest safe location and stop your vehicle.
2. Turn the engine off and check the engine oil level (For more details, refer
to “Engine Oil” section in chapter 9). If the level is low, add oil as required.
read more