Hyundai Santa Fe: Airbag Module / Curtain Airbag (CAB) Module. Repair procedures

Hyundai Santa Fe (TM) 2019-2024 Service Manual / Restraint / Airbag Module / Curtain Airbag (CAB) Module. Repair procedures

Removal

1.	Disconnect the battery negative cable and wait for at least 3 minutes before beginning work.

2.	Remove the roof trim assembly. (Refer to Body - "Roof Trim Assembly")

3.	Disconnect the curtain airbag connector.

4.	After loosening the mounting bolts & nuts remove the curtain airbag.

Installation

1.	Turn the ignition switch OFF.

2.	Disconnect the battery negative cable and wait for at least three minutes.

Tighten the curtain airbag mounting bolts.

Tightening torque

Bolts : 7.8 - 11.8 N.m (0.8 - 1.2 kgf.m, 5.8 - 8.7 lb-ft)

Nuts : 3.9 - 5.9 N.m (0.4 - 0.6 kgf.m, 2.9 - 4.3 lb-ft)

•	Never twist the airbag module when installing it. If the module is twisted, the airbag module may operate abnormally.

4.	Connect the curtain airbag connector.

5.	Install the roof trim assembly. (Refer to Body - "Roof Trim Assembly")

6.	Reconnect the battery negative cable.

7.	After installing the curtain airbag (CAB), confirm proper system operation: Turn the ignition switch ON; the SRS indicator light should turn on for about six seconds and then go off.

Curtain Airbag (CAB) Module. Components and components location

Airbag Module Disposal. Description and operation

Airbag Disposal When you scrap a vehicle equipped with an airbag, you must deploy it first. When you deploy an airbag, you need to have a skilled mechanic do the work...

Other information:

Hyundai Santa Fe (TM) 2019-2024 Service Manual: Engine Mounting. Repair procedures

Removal and Installation • Be careful not to damage the parts located under the vehicle (floor under cover, fuel filter, fuel tank and canister) when raising the vehicle using the lift...

Hyundai Santa Fe (TM) 2019-2024 Owner's Manual: Tire sidewall labeling

This information identifies and describes the fundamental characteristics of the tire and also provides the tire identification number (TIN) for safety standard certification. The TIN can be used to identify the tire in case of a recall. 1. Manufacturer or brand name Manufacturer or brand name is shown...