Hyundai Santa Fe: Automatic Transaxle Cooling System / Description and operation

Hyundai Santa Fe (TM) 2019-2024 Service Manual / Automatic Transaxle System (SBC) / Automatic Transaxle Cooling System / Description and operation

Description

•	Engine coolant is used for circulating heat in order to heat and cool the transaxle oil.

•	Prevents over heating of the transaxle oil while the vehicle is moving.

Coolant Flow

Automatic Transaxle Cooling System

Oil Cooler. Repair procedures

Repair procedures • ATF cooler is a unit with the radiator, so refer to radiator removal/installation procedures in the engine section...

Other information:

Hyundai Santa Fe (TM) 2019-2024 Service Manual: Overhead Console Lamp. Repair procedures

Inspection 1. Remove the overhead console lamp assembly then check for continuity between terminals. If the continuity is not as specified, replace the map lamp switch. Pin Descripton 1 Door 2 - 3 Battery (+) 4 - 5 Ground 6 Room lamp Removal 1...

Hyundai Santa Fe (TM) 2019-2024 Service Manual: Walk-in Switch. Repair procedures

Removal Actuator 1. Remove the rear seat. (Body - "Rear Seat Assembly") 2. Disconnect the walk in actuator connector and then remove the actuator. 3...

Categories

Air bag collision sensors

WARNING

To reduce the risk of an air bag deploying unexpectedly and causing serious injury or death:

Do not hit or allow any objects to impact the locations where air bags or sensors are installed. Do not perform maintenance on or around the air bag sensors. If the location or angle of the sensors is altered, the air bags may deploy when they should not or may not deploy when they should. Installing bumper guards with nongenuine Hyundai or non-equivalent parts may adversely affect the collision and airbag deployment performance. Press the Engine Start/Stop button to the OFF or ACC position and wait for 3 minutes when the vehicle is being towed to prevent inadvertent air bag deployment. Have all air bag repairs performed by an authorized HYUNDAI dealer.