Hyundai Santa Fe: Emergency Call System / Emergency Call (eCall) Antenna. Repair procedures
eCall Antenna
1. |
Disconnect the negative (-) battery terminal.
|
2. |
Remove the roof trim assembly.
(Refer to Body - "Roof Trim Assembly")
|
3. |
Disconnect the eCall antenna cable and connector (A) and then remove
the antenna mounting nut.

|
eCall Anenna
1. |
Connect the eCall antenna connectors.
|
2. |
Install the roof trim assembly.
• |
Make sure that the cables and connectors are plugged
in properly.
|
• |
Check the Ecall system.
|
|
|
REMOVAL
1.
Disconnect the negative (-) battery terminal.
2.
Remove the crash pad lower panel...
Other information:
Turn signal indicator light
This indicator light blinks:
When you operate the turn signal indicator stalk.
If any of the following occur, there may be a malfunction with the turn signal
system.
- The turn signal indicator light illuminates but does not blink
- The turn signal indicator light blinks rapidly
- The turn signal indicator light does not illuminate at all
If any of these conditions occur, have the vehicle inspected by an authorized
HYUNDAI dealer...
Blade fuse / Cartridge fuse
1. Turn the vehicle off.
2. Turn all other switches off.
3. Remove the fuse panel cover by pressing the tap and pulling up.
4. Check the removed fuse; replace it if it is blown. To remove or insert the fuse,
use the fuse puller in the engine compartment fuse panel...
Categories
Engine oil pressure warning light
.png)
This warning light illuminates:
When the engine oil pressure is low.
If the engine oil pressure is low:
1. Drive carefully to the nearest safe location and stop your vehicle.
2. Turn the engine off and check the engine oil level (For more details, refer
to “Engine Oil” section in chapter 9). If the level is low, add oil as required.
read more