Hyundai Santa Fe: Driving your vehicle / Engine Start/Stop button
Whenever the front door is opened, the Engine Start/Stop button will illuminate
and will go off 30 seconds after the door is closed.
WARNING
To turn the vehicle off in an emergency:
Press and hold the Engine Start/Stop button for more than two seconds OR Rapidly
press and release the Engine Start/Stop button three times (within three seconds).
If the vehicle is still moving, you can restart the vehicle without depressing
the brake pedal by pressing the Engine Start/Stop button with the gear in the N
(Neutral) position.
WARNING
- NEVER press the Engine Start/Stop button while the vehicle is in
motion except in an emergency. This will result in the vehicle turning off and
loss of power assist for the steering and brake systems. This may lead to loss
of directional control and braking function, which could cause an accident.
- Before leaving the driver’s seat, always make sure the gear is in
the P (Park) position, set the parking brake, press the Engine Start/Stop button
to the OFF position, and take the Smart Key with you. Unexpected vehicle movement
may occur if these precautions are not followed.
- NEVER reach through the steering wheel for the Engine Start/Stop
button or any other control while the vehicle is in motion. The presence of
your hand or arm in this area may cause a loss of vehicle control resulting
in an accident.
WARNING
Always wear appropriate shoes when operating your vehicle. Unsuitable
shoes, such as high heels, ski boots, sandals, flip-flops, etc., may interfere
with your ability to use the brake, accelerator and clutch pedals...
Other information:
When the ignition switch is in the ON position or when the engine is running,
press the heated steering wheel button to warm the steering wheel.
The indicator on the button will illuminate.
To turn the heated steering wheel off, press the button again...
Removal
•
In order to remove the front glass, use the tools shown in the
following figure:
[Tooling Diagram]
① Square wire
② Insert-type wire grip
[Tooling Assembly Diagram]
•
Insert and affix square wire ① into the insert hole of the wire
grip ②...
Categories
WARNING
To reduce the risk of an air bag deploying unexpectedly and causing serious
injury or death:
Do not hit or allow any objects to impact the locations where air
bags or sensors are installed.
Do not perform maintenance on or around the air bag sensors. If
the location or angle of the sensors is altered, the air bags may deploy when
they should not or may not deploy when they should.
Installing bumper guards with nongenuine Hyundai or non-equivalent
parts may adversely affect the collision and airbag deployment performance.
Press the Engine Start/Stop button to the OFF or ACC position and
wait for 3 minutes when the vehicle is being towed to prevent inadvertent air
bag deployment.
Have all air bag repairs performed by an authorized HYUNDAI dealer.
read more