Hyundai Santa Fe: Front Door / Front Door Outside Handle. Repair procedures
1. |
Remove the plug hole (B).
|
2. |
After loosening the mounting bolt, remove the front door outside handle
(A).
Tightening torque :
7.8 - 11.8 N.m (0.8 - 1.2 kgf.m, 5.8 - 8.7 lb-ft)
|

|
3. |
Press the lock pin and separate the front door outside handle connector
(A).

|
4. |
Remove the front door lock assembly (A).

|
5. |
To install, reverse removal procedure.
• |
Make sure the connector is connected properly.
|
• |
Make sure the door locks / unlocks and opens / closes
properly.
|
• |
Be sure to install the outside handle pad (A) between
the outside handle and the door panel.

|
|
|
Other information:
..
General Service Information
Protection of the Vehicle
Always be sure to cover fenders, seats, and floor areas prior to beginning work.
•
The support rod must be inserted into the hole near the edge
of the hood whenever you inspect the engine compartment to prevent
the hood from falling and causing possible injury...
Categories
Electric Power Steering (EPS) warning light
.png)
This warning light illuminates:
When you set the ignition switch or the Engine Start/Stop button to
the ON position.
- The electric power steering warning light illuminates for about 3 seconds
and then goes off.
Whenever there is a malfunction with the electric power steering.
If this occurs, have the vehicle inspected by an authorized HYUNDAI dealer.
read more