Hyundai Santa Fe: Light bulbs / High mounted stop lamp replacement
If the LED lamp (1) does not operate, we recommend that the system be inspected
by an authorized HYUNDAI dealer.
The LED lamps cannot be replaced as a single unit because it is an integrated
unit. The LED lamps has to be replaced with the unit.
A skilled technician should check or repair the LED lamp, for it may damage related
parts of the vehicle.
Type A
(1) Tail/Stop lamp
(2) Tail lamp
(3) Turn signal lamp
(4) Reverse lamp
(5) Side marker lamp
Stop/Tail lamp (Outside), Reverse lamp
1. Turn off the engine...
1. Using a flat-blade screwdriver, gently pry the lens cover from the lamp housing.
2. Remove the bulb by pulling it straight out.
3. Install a new bulb...
Other information:
4 Wheel Drive (4WD) LOCK Indicator Light
This indicator light illuminates:
Once you set the ignition switch or Engine Start/Stop Button to the
ON position.
- It illuminates for approximately 3 seconds and then goes off.
When you select 4WD Lock mode by pressing the 4WD LOCK button...
If the engine stalls while driving
Reduce your speed gradually, keeping a straight line. Move cautiously
off the road to a safe place.
Turn on your hazard warning flasher.
Try to start the engine again. If your vehicle will not start, we recommend
that you contact an authorized HYUNDAI dealer or seek other qualified assistance...
Categories
1. Driver’s front air bag
2. Passenger’s front air bag
3. Side air bag
4. Curtain air bag
The vehicles are equipped with a Supplemental Air Bag System for the driver’s
seat and front passenger’s seats.
The front air bags are designed to supplement the three-point seat belts. For
these air bags to provide protection, the seat belts must be worn at all times when
driving.
read more