Hyundai Santa Fe: Indicators And Gauges / Instrument Cluster. Components and components location

Hyundai Santa Fe (TM) 2019-2025 Service Manual / Body Electrical System / Indicators And Gauges / Instrument Cluster. Components and components location

Components

MONO TFT LCD 3.5 Inch

TFT LCD 4.2 Inch

Color 12.3 Inch

Connector Pin Information

No.	Connector A	No.	Connector
1	Ground	21	Trip switch (-)
2	Illumination (-)	22	Trip switch 1 (+)
3	Rheostat switch (Down)_Input	23	Trip switch 2 (+)
4	Rheostat switch (Up)_Input	24	Active ECO_input switch/ R switch(M/T)_input
5	Dentent	25	Driver mode switch/ N switch(M/T)_input
6	P	26	Speaker1 (+)_Output
7	R	27	Speaker1 (-)_Output
8	N	28	Low washer level_Input
9	D	29	M-CAN (Low)
10	S	30	M-CAN (High)
11	Immobilizer_Input	31	Engine run state_Output
12	Vehicle speed_Output	32	C-CAN (High)
13	AlTL_Input	33	C-CAN(Low)
14	Fuel sender (+)_Input	34	Outside temperature_Input
15	Vehicle speed_Input	35	-
16	Fuel sender (-)_Input	36	Heated steering wheel indicator_Input
17	Water separate_Input	37	Ground
18	Airbag (+)_Input	38	IGN 3
19	Oilpressure switch_Input	39	IGN 1
20	Taillamp_Input	40	Battery (+)

Instrument Cluster. Description and operation

Instrument Cluster. Schematic diagrams

Other information:

Hyundai Santa Fe (TM) 2019-2025 Service Manual: Side Impact Sensor (SIS). Repair procedures

Removal • Removal of the airbag must be performed according to the precautions/procedures described previously. • Do not turn the ignition switch ON and do not connect the battery cable while replacing the side impact sensor...

Hyundai Santa Fe (TM) 2019-2025 Service Manual: Repair procedures

Adjustment Description The friction material inside the coupling will degrade over time. Therefore, corresponding compensation values must be referenced and entered after replacing the controller or the coupling. Compensation Requirement and Procedure 1...

Categories

Air bag collision sensors

WARNING

To reduce the risk of an air bag deploying unexpectedly and causing serious injury or death:

Do not hit or allow any objects to impact the locations where air bags or sensors are installed. Do not perform maintenance on or around the air bag sensors. If the location or angle of the sensors is altered, the air bags may deploy when they should not or may not deploy when they should. Installing bumper guards with nongenuine Hyundai or non-equivalent parts may adversely affect the collision and airbag deployment performance. Press the Engine Start/Stop button to the OFF or ACC position and wait for 3 minutes when the vehicle is being towed to prevent inadvertent air bag deployment. Have all air bag repairs performed by an authorized HYUNDAI dealer.