Hyundai Santa Fe: Fuses / Instrument panel fuse replacement
.png)
1. Turn the vehicle off.
2. Turn all other switches off.
3. Open the fuse panel cover.
4. Refer to the label on the inside of the fuse panel cover to locate the suspected
fuse location.
.png)
5. Pull the suspected fuse straight out. Use the removal tool (1) provided in
the engine compartment fuses panel cover.
6. Check the removed fuse; replace it if it is blown. Spare fuses are provided in
the instrument panel fuse panels (or in the engine compartment fuse panel).
7. Push in a new fuse of the same rating, and make sure it fits tightly in the clips.
If it fits loosely, we recommend that you consult an authorized HYUNDAI dealer.
In an emergency, if you do not have a spare fuse, use a fuse of the same rating
from a circuit you may not need for operating the vehicle, such as the cigarette
lighter fuse.
If the headlamps or other electrical components do not work and the fuses are
undamaged, check the fuse panel in the engine compartment. If a fuse is blown, it
must be replaced with the same rating.
A vehicle’s electrical system is protected from electrical overload damage by
fuses.
This vehicle has 5 fuse panels, one located in the driver’s side panel bolster,
the other in the engine compartment...
Blade fuse / Cartridge fuse
1. Turn the vehicle off.
2. Turn all other switches off.
3. Remove the fuse panel cover by pressing the tap and pulling up...
Other information:
Navigation-based Smart Cruise Control may not operate normally under the following
circumstances:
The navigation is not working properly
Speed limit and road information in the navigation is not updated
The map information and the actual road is different because of real-time
GPS data or map information error
The navigation searches for a route while driving
GPS signals are blocked in areas such as a tunnel
The navigation is updated while driving
Map information is not transmitted due to infotainment system's abnormal
operation
A road that divides into two or more roads and joins again
The driver goes off course the route set in the navigation
The route to the destination is changed or canceled by resetting the navigation
The vehicle enters a service station or rest area
The speed limit of some sections changes according to the road situations
Android Auto or Car Play is operating
The navigation cannot detect the current vehicle position (ex: elevated
roads including overpass adjacent to general roads or nearby roads exist in
a parallel way)
The navigation is being updated while driving
The navigation is being restarted while driving
There is bad weather, such as heavy rain, heavy snow, etc...
Disassembly
•
Be careful not to damage the parts located under the vehicle
(floor under cover, fuel filter, fuel tank and canister) when
raising the vehicle using the lift...
Categories
Electric Power Steering (EPS) warning light
.png)
This warning light illuminates:
When you set the ignition switch or the Engine Start/Stop button to
the ON position.
- The electric power steering warning light illuminates for about 3 seconds
and then goes off.
Whenever there is a malfunction with the electric power steering.
If this occurs, have the vehicle inspected by an authorized HYUNDAI dealer.
read more