Hyundai Santa Fe: Lighting System / Rear Combination Lamp. Repair procedures

Hyundai Santa Fe (TM) 2019-2024 Service Manual / Body Electrical System / Lighting System / Rear Combination Lamp. Repair procedures

Removal

1.	Disconnect the negative (-) battery terminal.

2.	Remove the rear combination lamp mounting cap (A).

3.	Loosen the mounting bolts then remove the outside rear combination lamp (A).

4.	Disconnect the rear combination lamp connector (A).

5.	Remove the bulb after turning it in the counter clock-wise direction.

6.	Remove the rear combination cover (A).

7.	Remove the inside rear combination lamp assembly after loosening the nuts and disconnecting the connector.

8.	Remove the bulb after disconnecting the connector.

Installation

1.	Install the tailgate combination lamp assembly after assembling the bulb.

2.	Install the lamp cover to the tailgate after connecting the lamp connector.

3.	Install the rear combination lamp assembly after assembling the bulbs and connecting the lamp connector.

Luggage Room Lamp. Repair procedures

Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the luggage room lamp lens (A) with a flat-tip screwdriver...

Center Garnish Lamp. Repair procedures

Removal • When removing with a flat - tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components...

Other information:

Hyundai Santa Fe (TM) 2019-2024 Service Manual: IMS Control Switch. Repair procedures

Inspection 1. Disconnect the IMS control switch connector. 2. With the power IMS control switch in each position, make sure that continuity exists between the terminals below...

Hyundai Santa Fe (TM) 2019-2024 Owner's Manual: Trip computer mode. Turn By Turn (TBT) mode

Trip computer mode The trip computer mode displays information related to vehicle driving parameters including fuel economy, tripmeter information and vehicle speed. For more information, refer to "Trip Computer" in this chapter. Turn By Turn (TBT) mode Turn-by-turn navigation, distance/time to destination information is displayed when Turn by Turn view is selected...