Hyundai Santa Fe: Rear Suspension System / Rear Upper Arm. Repair procedures

Hyundai Santa Fe (TM) 2019-2025 Service Manual / Suspension System / Rear Suspension System / Rear Upper Arm. Repair procedures

Removal

1.	Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported.

Remove the rear wheel and tire (A) from rear hub.

Tightening torque :

107.9 - 127.5 N.m (11.0 - 13.0 kgf.m, 79.6 - 94.0 lb-ft)

•	Be careful not to damage the hub bolts when removing the rear wheel and tire (A).

Remove the rear upper arm (A) after loosening the mounting bolt and nut.

Tightening torque :

156.9 - 176.5 N.m (16.0 - 18.0 kgf.m, 115.7 - 130.2 lb-ft)

•	Set up the transmission jack under the lower arm in order to remove it in no-load condition.

Inspection

1.	Check the bushing for wear and deterioration.

2.	Check the rear upper arm or damage and deformation.

3.	Check for all bolts and nut.

Installation

1.	To install, reverse the removal procedures.

2.	Check the alignment. (Refer to Suspension System - "Alingment")

Rear Shock Absorber. Repair procedures

Removal 1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. 2...

Rear Lower Arm. Repair procedures

Removal 1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. 2...

Other information:

Hyundai Santa Fe (TM) 2019-2025 Service Manual: Front Door Belt Outside Weatherstrip. Repair procedures

Replacement 1. Pull down the front door window glass to the lowest level by pressing the power window glass switch. 2. Using a screwdriver or remover, remove the front door belt outside weatherstrip (A)...

Hyundai Santa Fe (TM) 2019-2025 Service Manual: Special service tools

Special Service Tools Tool(Number and Name) Illustration Use Deployment tool 0957A-34100A Airbag deployment tool. Use with (0957A-AL140, 0957A-AL160) Dummy 0957A-38200 Simulator to check the resistanceof each wiring harness...