Hyundai Santa Fe: Cowl Top Cover / Repair procedures

Hyundai Santa Fe (TM) 2019-2024 Service Manual / Body (Interior and Exterior) / Cowl Top Cover / Repair procedures

Replacement
1.
Remove the cap and the nuts, and then remove the wiper arm (A).
Tightening torque :
22.6 - 26.5 N.m (2.3 - 2.7 kgf.m, 16.6 - 19.5 lb-ft)

2.
Disconnect the washer nozzle (A).
3.
Detach the clips, then remove the cowl top cover (B).

4.
To install, reverse removal procedure.
  
Replace any damaged clips (or pin-type retainers).

    Components and components location

    ..

    Floor Console

    ..

    Other information:

    Hyundai Santa Fe (TM) 2019-2024 Service Manual: USB Jack. Repair procedures


    Removal    • When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components...

    Hyundai Santa Fe (TM) 2019-2024 Owner's Manual: Blind-Spot View Monitor (BVM)


    Blind-Spot View Monitor displays the rear blind spot area of the vehicle in the cluster when the turn signal is turned on to help change lanes. Detecting sensor [1], [2] : SVM-side view camera (camera located at bottom of the mirror) Refer to the picture above for the detailed location of the detecting sensors...

    Categories

    Air bag - supplemental restraint system

    1. Driver’s front air bag
    2. Passenger’s front air bag
    3. Side air bag
    4. Curtain air bag

    The vehicles are equipped with a Supplemental Air Bag System for the driver’s seat and front passenger’s seats.

    The front air bags are designed to supplement the three-point seat belts. For these air bags to provide protection, the seat belts must be worn at all times when driving.

    read more


     
    Copyright © 2024 www.hsafe4.com