Hyundai Santa Fe: Rear Door / Repair procedures

Hyundai Santa Fe (TM) 2019-2025 Service Manual / Body (Interior and Exterior) / Rear Door / Repair procedures

Adjustment

Glass Adjustment

•	Check the glass run channel for damage or deterioration, and replace them if necessary.

1.	Remove the rear door trim. (Refer to Rear Door - "Rear Door Trim")

2.	Remove the plug hole (A).

3.	After loosening the glass mounting bolts, adjust the spacing of the glass (A) by moving the glass from side to side and then tighten the bolts.

4.	Check the glass for normal operation.

Door Striker Adjustment

•	Make sure the door latches securely without slamming it. If necessary adjust the striker (A). The striker nuts are fixed. The striker can be fine adjusted up or down, and in or out.

After loosening the mounting screw, adjust the striker (A) by moving it forward and backward or from side to side and then tighten the bolts (B).

Tightening torque

21.6 - 32.4 N.m (2.2 - 3.3 kgf.m, 15.9 - 23.9 lb-ft)

2.	Check that door opening and closing works properly.

Door Position Adjustment

•	After installing the rear door, check that the body fits flush with/parallel to all the edges of front door. Check that the door and body edges are parallel. Before adjusting, replace the mounting bolts.

1.	Check that the door and body edges are parallel.

2.	Place the vehicle on a firm, level surface when adjusting the doors.

Adjust the hinges (A) :

•	Loosen the door mounting bolts slightly, and move the door in or out until it aligns flush with the body.

•	Loosen the hinge mounting bolts slightly, and move the door backward or forward, up or down as necessary to make the gaps equal.

•	Place a shop towel on the jack to prevent damage to the door when adjusting the door.

Tightening torque

(B) : 21.6 - 26.5 N.m (2.2 - 2.7 kgf.m, 15.9 - 19.5 lb-ft)

4.	Grease the pivot portions of the hinges indicated by the arrows.

5.	Check for water leaks.

Components and components location

Components 1. Rear door window glass 2. Rear door window glass run assembly 3. Rear door outside handle 4. Rear door outside handle pad 5...

Rear Door Trim. Components and components location

Other information:

Hyundai Santa Fe (TM) 2019-2025 Service Manual: Output Speed Sensor. Description and operation

Description The output speed sensor is a vital unit that measures the rate of rotation of the transaxle's turbine shaft and output shaft, and delivers the readings to the TCM. The sensor provides critical input data that's used in feedback control, damper clutch control, gear setting control, line pressure control, clutch activation pressure control, and sensor fault analysis...

Hyundai Santa Fe (TM) 2019-2025 Service Manual: AVN Keyboard Assembly. Repair procedures

Removal 1. Disconnct the negative (-) battery terminal. 2. Using a remover, remove the console upper cover (A). 3. Disconnect the console upper cover connector (A)...