Hyundai Santa Fe: Cruise Control System (CC) / Schematic diagrams
Component Parts And Function Outline
Component part
|
Function
|
Vehicle-speed sensor, ESP/ABS Control Module
|
Converts vehicle speed to pulse.
|
ECM
|
Receives signals from sensor and control switches.
|
Cruise control indicator
|
Illuminate when CRUISE main switch is ON (Built into cluster)
|
Cruise Control switches
|
CRUISE switch
|
Switch for automatic speed control power supply.
|
Resume/Accel switch (RES +)
|
Controls automatic speed control functions by Resume/Accel switch (Set/Coast
switch)
|
Set/Coast switch (RES -)
|
Cancel switches
|
Cancel switch
|
Sends cancel signals to ECM.
|
Brake-pedal switch
|
Transaxle range switch (A/T)
|
ETC Motor
|
Regulates the throttle valve to the set opening by ECM.
|
* ETC Motor : Electronic Throttle Control Motor
Trouble Symptom Charts
Trouble Symptom 1
Trouble Symptom 2
Trouble symptom
Probable cause
Remedy
The set vehicle speed varies greatly upward or downward
"Surging" (repeated alternating acceleration and deceleration) occurs after
setting
Malfunction of the vehicle speed sensor circuit
Repair the vehicle speed sensor system, or replace the part
Malfunction of ECM
Check input and output signals at ECM
Trouble Symptom 3
Trouble symptom
Probable cause
Remedy
The CC system is not canceled when the brake pedal is depressed
Damaged or disconnected wiring of the brake pedal switch
Repair the harness or replace the brake pedal switch
Malfunction of the ECM signals
Check input and output signals at ECM
Trouble Symptom 4
Trouble symptom
Probable cause
Remedy
The CC system is not canceled when the shift lever is moved to the "N" position
(It is canceled, however, when the brake pedal is depressed)
Damaged or disconnected wiring of inhibitor switch input circuit
Repair the harness or repair or replace the inhibitor switch
Improper adjustment of inhibitor switch
Malfunction of the ECM signals
Check input and output signals at ECM
Trouble Symptom 5
Trouble symptom
Probable cause
Remedy
Cannot decelerate (coast) by using the "SET/–" switch
Temporary damaged or disconnected wiring of "SET/–" switch input circuit
Repair the harness or replace the "SET/–" switch
Malfunction of the ECM signals
Check input and output signals at ECM
Trouble Symptom 6
Trouble symptom
Probable cause
Remedy
Cannot accelerate or resume speed by using the "RES/+" switch
Damaged or disconnected wiring, or short circuit, or "RES/+" switch input
circuit
Repair the harness or replace the "RES/+" switch
Malfunction of the ECM signals
Check input and output signals at ECM
Trouble Symptom 7
Trouble symptom
Probable cause
Remedy
CC system can be set while driving at a vehicle speed of less than 40km/h
(25mph), or there is no automatic cancellation at that speed
Malfunction of the vehicle-speed sensor circuit
Repair the vehicle speed sensor system, or replace the part
Malfunction of the ECM signals
Check input and output signals at ECM
Trouble Symptom 8
Trouble symptom
Probable cause
Remedy
The cruise main switch indicator lamp does not illuminate (But CC system
is normal)
Damaged or disconnected bulb of cruise main switch indicator lamp
Repair the harness or replace the part...
Other information:
The severe weather conditions of winter quickly wear out tires and cause other
problems. To minimize winter driving problems, you should take the following suggestions:
Snow or icy conditions
You need to keep sufficient distance between your vehicle and the vehicle in
front of you...
Removal
1.
Prior to replacing the 4WD ECU, check the 4WD ECU's clutch learing with
the diagnostic tool.
(Refer to 4WD Control System - "Repair Procedures")
2.
Turn OFF ignition switch and the disconnect the negative (-) battery
cable...
Categories
The armrest is located in the center of the rear seat. Pull the armrest down
from the seatback to use it.
read more