Inspection |
1. |
Problem in SMART KEY unit input.
|
2. |
Problem in SMART KEY unit.
|
3. |
Problem in SMART KEY unit output.
|
4. |
SMART KEY unit Input problem : switch diagnosis
|
5. |
SMART KEY unit problem : communication diagnosis
|
6. |
SMART KEY unit Output problem : antenna and switch output diagnosis
|
1. |
In the body electrical system, failure can be quickly diagnosed by using
the vehicle diagnostic system (diagnostic tool).
The diagnostic system(diagnostic tool) provides the following information.
|
2. |
If diagnose the vehicle by diagnostic tool, select "DTC Analysis" and
"Vehicle".
|
3. |
If check current status, select the "Data Analysis" and "Car model".
|
4. |
Select the SMK' to be checked in order to check the vehicle with the
tester.
|
5. |
You can see the situation of each switch on scanner after connecting
the "current data" process.
|
1. |
Fault code searching that the each linked components operates normal.
|
2. |
Connect the cable of diagnostic tool to the data link connector in driver
side crash pad lower panel.
|
3. |
Select the 'Fault Code Searching' and 'Car model'.
|
1. |
Connect the cable of diagnostic tool to the data link connector in driver
side crash pad lower panel.
|
2. |
Select the 'Actuation Test' and 'Car model'.
|
3. |
Set the smart key near the related antenna and operate it with a diagnostic
tool.
|
4. |
Set the smart key near the related antenna and operate it with a diagnostic
tool.
|
5. |
If the LED of smart key is blinking, the smart key is normal.
|
6. |
If the LED of smart key is not blinking, check the voltage of smart
key battery.
|
7. |
Antenna actuation
|
1. |
Connect the cable of diagnostic tool to the data link connector in driver
side crash pad lower panel.
|
2. |
Select the 'S/W Management' and 'Car model'.
|
3. |
Select the 'Smart Key Unit' and 'Antenna Status Check'.
|
4. |
Set the smart key near the related antenna and operate it with a diagnostic
tool.
|
5. |
If the smart key runs normal , the related antenna, smart key(transmission,
reception) and exterior receiver are normal.
|
6. |
Antenna status
|
1. |
Connect the cable of diagnostic tool to the data link connector in driver
side crash pad lower panel.
|
2. |
Select the 'S/W Management' and 'Car model'.
|
3. |
Select the 'Smart Key Unit' and 'FOB KEY STATUS IMFORMATION'.
|
1. |
Connect the cable of diagnostic tool to the data link connector in driver
side crash pad lower panel.
|
2. |
Select the 'S/W Management' and 'Car model'.
|
3. |
Select the 'Smart Key Unit' and 'SMK STATUS INFORMATION'.
|
1. |
Connect the cable of diagnostic tool to the data link connector in driver
side crash pad lower panel.
|
2. |
Select the 'S/W Management' and 'Car model'.
|
3. |
Select the 'Smart Key Unit' and 'Neutralization Mode'.
|
Engine oil pressure warning light
This warning light illuminates:
When the engine oil pressure is low.
If the engine oil pressure is low:
1. Drive carefully to the nearest safe location and stop your vehicle.
2. Turn the engine off and check the engine oil level (For more details, refer to “Engine Oil” section in chapter 9). If the level is low, add oil as required.