Hyundai Santa Fe: Surround View Monitor (SVM) / Surround View Monitor (SVM) Camera. Repair procedures

Hyundai Santa Fe (TM) 2019-2024 Service Manual / Advanced Driver Assistance System (ADAS) / Surround View Monitor (SVM) / Surround View Monitor (SVM) Camera. Repair procedures

Removal

•	In case of bad quality or poor focus, be sure to check the camera lense surface condition and foreign materials.

Front Camera

1.	Disconnect the negative (-) battery terminal.

2.	Remove the front bumper cover. (Refer to Body - "Front Bumper Cover")

3.	Remove the pantocscpic camera after loosening the mounting screws and connector.

Rear Camera

1.	Remove the tailgate trim. (Refer to Body - "Tailgate Trim")

2.	Remove the tailgate ganish (A).

3.	Remove the tailgate switch assembly.

4.	Remove the license lamp LH.

5.	Disconnector the connector (A) and then remove the rear view camera.

Left/ Right Camera

1.	Disconnect the negative (-) battery terminal.

2.	Remove the mirror. (Refer to Power Door Mirror - "Power Door Mirror Actuator")

3.	Remove the outside mirror cover. (Refer to Power Door Mirror - "Power Door Mirror Actuator")

4.	Disconnect the camera conenctor and then remove the camera (A).

Installation

Front Camera

1.	Install the front camera.

2.	Install the front bumper cover.

Rear Camera

1.	Install the rear camera.

2.	Install the tail gate switch assemblyl.

3.	Install the tail gate trim. (Refer to Body - "Tail Gate Trim")

Left/Right Camera

1.	Install the left/right camera.

2.	Install the door mirror.

Surround View Monitor (SVM) Camera. Components and components location

Parking/View Switch. Repair procedures

Removal • When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components...

Other information:

Hyundai Santa Fe (TM) 2019-2024 Service Manual: Front Door Side Weatherstrip. Repair procedures

Replacement [Front door side weatherstrip] 1. Loosen the front door checker (B) mounting bolt. Tightening torque : 21.6 - 32.4 N.m (2.2 - 3.3 kgf.m,15.9 - 23.9 lb-ft) 2...

Hyundai Santa Fe (TM) 2019-2024 Owner's Manual: If the engine overheats

If your temperature gauge indicates overheating, you experience a loss of power, or hear loud pinging or knocking, the engine may be overheating. If this happens, you should: 1. Pull off the road and stop as soon as it is safe to do so. 2. Shift the gear to P (Park) and set the parking brake...