Hyundai Santa Fe (TM): Surround View Monitor (SVM) / Parking/View Switch. Repair procedures

Hyundai Santa Fe (TM) 2019-2023 Service and Repair Manual / Advanced Driver Assistance System (ADAS) / Surround View Monitor (SVM) / Parking/View Switch. Repair procedures

Removal
  
•
When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
•
Put on gloves to prevent hand injuries.
  
•
Take care not to bend or scratch the trim and panels.
1.
Disconnect the negative (-) battery terminal.
2.
Remove the console upper cover (A).
3.
Disconnect the console upper cover connectors (A).
4.
Loosen the mounting screws and remove parking/view switch (A)
Installation
1.
Install the parking/view switch.
2.
Install the console upper cover.
3.
Connect the negative (-) battery terminal.

    Removal    • In case of bad quality or poor focus, be sure to check the camera lense surface condition and foreign materials.

    Other information:

    Hyundai Santa Fe (TM) 2019-2023 Service and Repair Manual: Front Radar Unit. Components and components location

    Hyundai Santa Fe (TM) 2019-2023 Service and Repair Manual: Components and components location

    Component Location 1. Integrated Body Control Unit (IBU) 2. Ultrasonic Sensor ※ PDW function is applied alone, it is integrated into IBU (Integrated Body Control Unit). ※ PDW function is applied with RSPA function, it is integrated into ADAS_PRK controller.

    Categories

     
    Copyright © 2025 www.hsafe4.com - 0.0156