Hyundai Santa Fe: Warning and indicator lights / Turn signal indicator light. High beam indicator light
Turn signal indicator light
.png)
This indicator light blinks:
When you operate the turn signal indicator stalk.
If any of the following occur, there may be a malfunction with the turn signal system.
- The turn signal indicator light illuminates but does not blink
- The turn signal indicator light blinks rapidly
- The turn signal indicator light does not illuminate at all
If any of these conditions occur, have the vehicle inspected by an authorized HYUNDAI dealer.
High beam indicator light
.png)
This indicator light illuminates:
- When the headlights are on and in the high beam position
- When the turn signal lever is pulled into the Flash-to-Pass position.
Downhill Brake Control (DBC) indicator light. AUTO STOP indicator light
Downhill Brake Control (DBC) indicator light
This indicator light illuminates:
When you set the ignition switch or the Engine Start/Stop button to
the ON position...
High Beam Assist indicator light. Cruise Indicator Light
High Beam Assist indicator light
This indicator light illuminates:
When the high-beam is on with the light switch in the AUTO position.
White: When High Beam Assist is ready to operate...
Other information:
Hyundai Santa Fe (TM) 2019-2025 Service Manual: Rear Door Trim. Repair procedures
Replacement • Put on gloves to prevent hand injuries. • When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components...
Hyundai Santa Fe (TM) 2019-2025 Service Manual: Description and operation
Description The cruise control system is engaged by the cruise "ON/OFF" main switch located on right of steering wheel column. The system has the capability to cruise, coast, accelerate and resume speed. It also has a safety interrupt, engaged upon depressing brake or shifting select lever...
Categories
- Manuals Home
- 4th Generation Santa Fe Owners Manual
- 4th Generation Santa Fe Service Manual
- Child-protector rear door locks
- Brake bleeding procedures
- Electronic Parking Brake (EPB) warning light. AUTO HOLD indicator light
- New on site
- Most important about car
Engine oil pressure warning light. Low fuel level warning light
Engine oil pressure warning light
.png)
This warning light illuminates:
When the engine oil pressure is low.
If the engine oil pressure is low:
1. Drive carefully to the nearest safe location and stop your vehicle.
2. Turn the engine off and check the engine oil level (For more details, refer to “Engine Oil” section in chapter 9). If the level is low, add oil as required.
