
The USB charger is designed to recharge batteries of small size electrical devices using a USB cable.
The electrical devices can be recharged when the Engine Start/Stop button is in the ACC or ON (or START) position.
The battery charging state may be monitored on the electrical device.
Disconnect the USB cable from the USB port after use.
The power outlet is designed to provide power for mobile telephones or other devices designed to operate with vehicle electrical systems. The devices should draw less than 180 watts with the engine running.
The AC inverter supplies 115V/150W electric power to operate electric accessories or equipments. Information Rated voltage : AC 115 volts Maximum electric power : 150 watts In order to avoid an electrical system failure, electric shock, etc.
Inspection Operating Logic Test (Manual only) Inspect the PTC operation with the confirmation logic below : 1. Entering (1) Set the mode to FLOOR. (2) Set the temperature to MAX HOT.
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the carash pad lower panel. (Refer to Body - "Crash Pad Lower Panel") 3. Remove the crash pad center panel.