Removal |
1. |
Disconnect the negative (-) battery terminal.
|
2. |
Remove the steering wheel.
(Refer to - "Steering Wheel")
|
3. |
Remove the steering columm shround.
(Refer to - "Steering Columm Shround panel")
|
4. |
Remove the clock spring.
(Refer to Restraint - "Driver Airbag(DAB) and Clock Spring")
|
5. |
Remove the multifunction connector (A).
|
6. |
Remove the multifunction switch (A) after loosening the mounting screws
(2EA).
|
Installation |
1. |
Install the multifunction switch after connecting the connector.
|
2. |
Install the clock spring and steering.
|
3. |
Install the upper and lower shroud.
|
4. |
Install the steering wheel.
|
Inspection |
1. |
Check for continuity between the terminals in each switch position as
shown below.
|
1. |
In the body electrical system, failure can be quickly diagnosed by using
the vehicle diagnostic system (diagnostic tool).
The diagnostic system (diagnostic tool) provides the following information.
|
2. |
If diagnose the vehicle by diagnostic tool, select "DTC Analysis" and
"Vehicle".
|
3. |
If check current status, select the "Data Analysis" .
|
4. |
Select the 'IBU_BCM' to search the current state of the input/output
data.
|
The front seat can be adjusted by using the control switches located on the outside of the seat cushion. Before driving, adjust the seat to the proper position so that you can easily control the steering wheel, foot pedals and controls on the instrument panel.
WARNING
NEVER allow children in the vehicle unattended. The power seats are operable when the vehicle is turned off.