Hyundai Santa Fe: Engine Control System / Crankshaft Position Sensor (CKPS). Schematic diagrams

Hyundai Santa Fe (TM) 2019-2025 Service Manual / Engine Control/Fuel System / Engine Control System / Crankshaft Position Sensor (CKPS). Schematic diagrams

Circuit Diagram

Harness Connector

    Crankshaft Position Sensor (CKPS). Description and operation

    Description Crankshaft Position Sensor (CKPS) detects the crankshaft position and is one of the most important sensors of the engine control system...

    Crankshaft Position Sensor (CKPS). Repair procedures

    Inspection 1. Check the signal waveform of the CMPS and CKPS using the diagnostic tool. Specification : Refer to "DTC Diagnostic Guide" Removal    • Be careful not to damage the parts located under the vehicle (floor under cover, fuel filter, fuel tank and canister) when raising the vehicle using the lift...

    Other information:

    Hyundai Santa Fe (TM) 2019-2025 Service Manual: Joint Assembly (Transaxle side). Repair procedures


    Removal    • Drive shaft joints require special grease, so do not add any other type of grease. • When replacing the boot band, it must be a new one...

    Hyundai Santa Fe (TM) 2019-2025 Service Manual: Start/Stop Button. Repair procedures


    Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the driver crash pad lower panel. (Refer to Body - "Crash Pad Lower Panel") 3...

    Categories

    Engine oil pressure warning light. Low fuel level warning light

    Engine oil pressure warning light

    This warning light illuminates:

    When the engine oil pressure is low.

    If the engine oil pressure is low:

    1. Drive carefully to the nearest safe location and stop your vehicle.

    2. Turn the engine off and check the engine oil level (For more details, refer to “Engine Oil” section in chapter 9). If the level is low, add oil as required.

    read more


     
    Copyright © 2025 www.hsafe4.com