Hyundai Santa Fe (TM): Rear Door / Rear Door Frame Garnish. Repair procedures

Replacement
  
•
Put on gloves to prevent hand injuries.
  
•
When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
•
Be careful not to scratch the door trim and other parts.
[Rear door B pillar frame garnish]
1.
Remove the rear door belt outside weatherstrip.
(Refer to Rear Door - "Rear Door Outside Weatherstrip")
2.
Using a remover and remove the rear door B pillar garnish (A).

3.
To install, reverse removal procedure.
  
•
Replace any damaged clips (or pin-type retainers).
•
If any parts are damaged after removing the door frame garnish, replace it with a new one.
[Rear door C pillar frame garnish]
1.
Remove the rear door belt outside weatherstrip.
(Refer to Rear Door - "Rear Door Outside Weatherstrip")
2.
Using a screwdriver or remover, remove the rear door delta inner cover (A).

3.
Using a remover and remove the rear door C pillar garnish (A).

4.
To install, reverse removal procedure.
  
•
Replace any damaged clips (or pin-type retainers).
•
If any parts are damaged after removing the door frame garnish, replace it with a new one.

    Replacement [Rear door side weatherstrip] 1. Loosen the rear door checker (B) mounting bolt. Tightening torque : 21.

    Replacement    • Put on gloves to prevent hand injuries.

    Other information:

    Hyundai Santa Fe (TM) 2019-2023 Service and Repair Manual: Components and components location

    Hyundai Santa Fe (TM) 2019-2023 Service and Repair Manual: Troubleshooting

    Trouble Symptom Charts Trouble Symptom 1 Trouble Symptom 2 Trouble symptom Probable cause Remedy The set vehicle speed varies greatly upward or downward "Surging" (repeated alternating acceleration and deceleration) occurs after set

    Categories

     
    Copyright © 2025 www.hsafe4.com - 0.0147