Hyundai Santa Fe: Steering wheel / Heated steering wheel
.png)
When the ignition switch is in the ON position or when the engine is running, press the heated steering wheel button to warm the steering wheel.
The indicator on the button will illuminate.
To turn the heated steering wheel off, press the button again. The indicator on the button will turn off.
- Auto Comfort Control (for driver’s seat) (if equipped)
- The heated steering wheel automatically controls the steering wheel temperature
depending on the ambient temperature and the set climate control temperature when
the engine is running. If the heated steering wheel switch is pushed, the heated
steering wheel will have to be controlled manually. To use this function, it must
be activated from the Settings menu in the AVN system screen.
- The heated steering wheel defaults to the OFF position whenever the ignition switch
is ON. However, if the Auto Comfort Control function is ON, the heated steering
wheel will turn on and off depending on the ambient temperature and the set climate
control temperature.
Information
The heated steering wheel will turn off automatically approximately 30 minutes after the heated steering wheel is turned on.
NOTICE
Do not install any cover or accessory on the steering wheel. This cover or accessory could cause damage to the heated steering wheel system.
Tilt / Telescopic steering
When adjusting the steering wheel to a comfortable position, adjust the steering
wheel so that it points toward your chest, not toward your face. Make sure you can
see the instrument cluster warning lights and gauges...
Horn
To sound the horn, press the area indicated by the horn symbol on your steering
wheel (see illustration). The horn will operate only when this area is pressed...
Other information:
Hyundai Santa Fe (TM) 2019-2024 Owner's Manual: Forward Collision–Avoidance Assist (FCA) (Sensor fusion)
Basic function Forward Collision-Avoidance Assist is designed to help detect and monitor the vehicle ahead or help detect a pedestrian or cyclist in the roadway and warn the driver that a collision is imminent with a warning message and an audible warning, and if necessary, apply emergency braking...
Hyundai Santa Fe (TM) 2019-2024 Service Manual: Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the cover (A) by using a flat-tip screwdriver. 3. Disconnect the connector (A) and then remove the occupant alert sensor...
Categories
- Manuals Home
- 4th Generation Santa Fe Owners Manual
- 4th Generation Santa Fe Service Manual
- Brake bleeding procedures
- Power adjustment
- Fuel pressure test
- New on site
- Most important about car
Air bag collision sensors
WARNING
To reduce the risk of an air bag deploying unexpectedly and causing serious injury or death:
Do not hit or allow any objects to impact the locations where air bags or sensors are installed. Do not perform maintenance on or around the air bag sensors. If the location or angle of the sensors is altered, the air bags may deploy when they should not or may not deploy when they should. Installing bumper guards with nongenuine Hyundai or non-equivalent parts may adversely affect the collision and airbag deployment performance. Press the Engine Start/Stop button to the OFF or ACC position and wait for 3 minutes when the vehicle is being towed to prevent inadvertent air bag deployment. Have all air bag repairs performed by an authorized HYUNDAI dealer.