Hyundai Santa Fe: Button Engine Start System / Ignition Switch Assembly. Repair procedures

Hyundai Santa Fe (TM) 2019-2025 Service Manual / Body Electrical System / Button Engine Start System / Ignition Switch Assembly. Repair procedures

Inspection

1.	Disconnect the ignition switch connector (B) and key warning switch connector (A) from under the steering column.

2.	Check for continuity between the terminals.

3.	If continuity is not specified, replace the switch.

Removal

1.	Disconnect the negative (-) battery terminal.

2.	Remove the crash pad lower panel. (Refer to Body - "Crash Pad Lower Panel")

3.	Remove the steering column upper and lower shrouds. (Refer to Body - "Steering Column Shroud Panel")

4.	Remove the ignition switch (A) after disconnecting the 6P connector (B).

5.	Remove the key warning and immobilizer connector (A).

6.	If it is necessary to remove the key lock cylinder (A), remove the key lock cylinder with key ACC.

Installation

1.	Install the key lock cylinder.

2.	Install the key warning and immobilizer connector.

3.	Install the ignition switch.

4.	Install the steering column shrouds and crash pad lower panel.

Start/Stop Button. Repair procedures

Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the driver crash pad lower panel...

AC Inverter System

Other information:

Hyundai Santa Fe (TM) 2019-2025 Service Manual: Description and operating principle

Description and Operation Wireless Power Charger System During ACC or IG ON, battery voltage is supplied to the wireless power charger system to transmit an output of 5 W to mobile phone. Mobile phones certified with the wireless charging standard WPC (Qi 1...

Hyundai Santa Fe (TM) 2019-2025 Service Manual: Head Up Display Unit. Troubleshooting

Troubleshooting Category Error symptoms inspection item Detailed inspection item Related parts Lighting • HUD not working • Lighting brightness not automatically controlled (no difference between day and night) • Check the lighting control • Check the ambient light sensor operation • Check the CAN communication • Check the lighting control in the cluster USM → If working, HUD has no problem...