Hyundai Santa Fe: Automatic Transaxle Control System / Position Switch. Description and operation

Hyundai Santa Fe (TM) 2019-2025 Service Manual / Automatic Transaxle System (SBC) / Automatic Transaxle Control System / Position Switch. Description and operation

Description

•	The position switch mounted on the upper of transaxle and connected with shifter lever.

•	The position switch has four points of contact and it makes the signals(S1, S2, S3, S4).

•	The position switch signals delivered at the TCM according to control of the shift lever positions(P, R, N, D) and it is used to control of the gear setting.

Output Speed Sensor. Repair procedures

Inspection • Refer to the DTC manual for the check procedure...

Position Switch. Troubleshooting

Fault Diagnosis ▶ Fault Diagnosis for Symptom Major Symptom Expected Cause Items to Check and Measures Shift lever inoperable Faulty shift cable tension Adjust shift cable tension (refer to "Automatic Transaxle System – Position Switch") Faulty shift cable assembly/connection Check manual control valve assembly and re-assemble if necessary...

Other information:

Hyundai Santa Fe (TM) 2019-2025 Service Manual: Ignition Switch Assembly. Repair procedures

Inspection 1. Disconnect the ignition switch connector (B) and key warning switch connector (A) from under the steering column. 2. Check for continuity between the terminals...

Hyundai Santa Fe (TM) 2019-2025 Service Manual: Knock Sensor (KS). Description and operation

Description Knocking is a phenomenon characterized by undesirable vibration and noise and can cause engine damage. Knock Sensor (KS) is installed on the cylinder block and senses engine knocking. When knocking occurs, the vibration from the cylinder block is applied as pressure to the piezoelectric element...