Hyundai Santa Fe: SRSCM / SRS Control Module (SRSCM). Schematic diagrams

Hyundai Santa Fe (TM) 2019-2024 Service Manual / Restraint / SRSCM / SRS Control Module (SRSCM). Schematic diagrams

Supplemental Restraint System Control Module (SRSCM)

No	Connector A	Connector B
1	Driver airbag 2st stage (High)	-
2	Driver airbag 2st stage (Low)	-
3	Passenger airbag 2st stage (Low)	-
4	Passenger airbag 2st stage (High)	Driver seat belt anchor pretensioner (Low)
5	-	Driver seat belt anchor pretensioner (High)
6	-	Passenger seat belt anchor pretensioner (High)
7	Passenger airbag active air vent (Low)	Passenger seat belt anchor pretensioner (Low)
8	Passenger airbag active air vent (High)
9	-
10	B+
11	Crash output
12	Passenger airbag 1st stage (Low)
13	Passenger airbag 1st stage (High)	-
14	-	-
15	-	Passenger seat belt buckle sensor
16	Telltale lamp	-
17		Passenger curtain airbag (Low)
18	-	Passenger curtain airbag (High)
19	Driver airbag 1st stage - (High)	Driver curtain airbag (High)
20	Driver airbag 1st stage (Low)	Driver curtain airbag (Low)
21	-	Passenger side airbag (Low)
22	-	Passenger side airbag (High)
23	-	Driver side airbag (High)
24	-	Driver side airbag (Low)
25	-	-
26	C-CAN (Low)	-
27	C-CAN (High)	Driver seat belt pretensioner (Low)
28	IGN 1	Driver seat belt pretensioner (High)
29	Front impact sensor LH - (High)	-
30	Front impact sensor LH - (Low)	-
31	Front impact sensor RH - (Low)	-
32	Front impact sensor RH - (High)	Passenger seat belt pretensioner (High)
33		Passenger seat belt pretensioner (Low)
34		-
35	P-CAN (Low)	-
36	P-CAN (High))	-
37		-
38		-
39		-
40		Ground
41		Driver side rear impact sensor (Low)
42		Driver side rear impact sensor (High)
43		Driver pressure side impact sensor (High)
44		Driver pressure side impact sensor (Low)
45		Passenger pressure side impact sensor (Low)
46		Passenger pressure side impact sensor (High)
47		Driver side impact sensor (High)
48		Driver side impact sensor (Low)
49		Passenger side impact sensor (Low)
50		Passenger side impact sensor (High)
51		Passenger side rear impact sensor (High)
52		Passenger side rear impact sensor (Low)

SRS Control Module (SRSCM). Components and components location

SRS Control Module (SRSCM). Repair procedures

Removal 1. Turn the engine OFF. 2. Disconnect the battery negative cable and wait for at least three minutes before beginning work...

Other information:

Hyundai Santa Fe (TM) 2019-2024 Service Manual: Room Lamp. Repair procedures

Inspection 1. Remove the room lamp assembly then check for continuity between terminals. Removal 1. Disconnect the negative (-) battery terminal...

Hyundai Santa Fe (TM) 2019-2024 Service Manual: Heated Oxygen Sensor (HO2S). Description and operation

Description Heated Oxygen Sensor (HO2S) consists of zirconium and alumina and is installed both upstream and downstream of the Manifold Catalytic Converter. It varies in accordance with the air/fuel ratio. The sensor must be hot in order to operate normally...

Categories

Air bag collision sensors

WARNING

To reduce the risk of an air bag deploying unexpectedly and causing serious injury or death:

Do not hit or allow any objects to impact the locations where air bags or sensors are installed. Do not perform maintenance on or around the air bag sensors. If the location or angle of the sensors is altered, the air bags may deploy when they should not or may not deploy when they should. Installing bumper guards with nongenuine Hyundai or non-equivalent parts may adversely affect the collision and airbag deployment performance. Press the Engine Start/Stop button to the OFF or ACC position and wait for 3 minutes when the vehicle is being towed to prevent inadvertent air bag deployment. Have all air bag repairs performed by an authorized HYUNDAI dealer.