Hyundai Santa Fe: ESP(Electronic Stability Program) System / ESP OFF Switch. Repair procedures
1. |
Turn ignition switch OFF and disconnect the negative (-) battery cable.
|
2. |
Remove the crash pad lower panel.
(Refer to Body - "Crash Pad")
|
3. |
Remove the crash pad garnish assembly (A).
|
4. |
Remove the connector (A) by pressing the locking pin.
|
5. |
Remove the ESP OFF switch (A) after loosening the screw.
|
1. |
To install, reverse the removal procedures.
|
Description
1.
The ESP OFF switch is for the user to turn off the ESP system.
2.
The ESP OFF lamp is on when ESP OFF switch is engaged...
Other information:
Component Location
1. Integrated
Body Control Unit (IBU)
2. Ultrasonic
Sensor
※ PDW function is applied alone, it is integrated into IBU (Integrated Body
Control Unit).
※ PDW function is applied with RSPA function, it is integrated into ADAS_PRK
controller...
Replacement
•
Put on gloves to prevent hand injuries.
•
When removing with a flat-tip screwdriver or remover, wrap protective
tape around the tools to prevent damage to components...
Categories
Electric Power Steering (EPS) warning light
This warning light illuminates:
When you set the ignition switch or the Engine Start/Stop button to
the ON position.
- The electric power steering warning light illuminates for about 3 seconds
and then goes off.
Whenever there is a malfunction with the electric power steering.
If this occurs, have the vehicle inspected by an authorized HYUNDAI dealer.
read more